SIMCO HOLDINGS LIMITED · HONGKONG. SHANDONG. TIANJIN
WhatsApp

Coil inspection before shipment: a buyer checklist

Published 2026-10-09

A GI coil may meet the specified zinc coating weight at the coil ends but fall short in the middle. Checking only the visible surface or taking samples from the head and tail may not reveal the problem.

For buyers, pre-shipment inspection should go beyond appearance. The key is to verify the actual coating weight, check the product condition and confirm that the goods match the order.

1. Verify the Zinc Coating Weight

Zinc coating weight is one of the most important quality requirements for galvanized steel coils. Do not judge it by appearance alone. Use a suitable test method to verify that it meets the agreed specification.

Under commonly used coating designation systems, the specified coating mass is generally expressed as the total mass on both surfaces, in grams per square metre.

For example, Z275 represents a nominal coating mass designation of 275 g/m² for both sides combined under the applicable EN designation system.

It does not mean 275 g/m² on each side.

Beware of head-and-tail sampling.

Some suppliers may ensure that samples from the coil head and tail meet the required coating weight while using a lower coating weight in the middle. Testing only the two ends may therefore give buyers a misleading result.

To reduce this risk, ask the mill to unwind at least 500 metres before taking a sample. This is an additional quality-control recommendation, not a requirement under EN or ASTM standards. It helps reduce the risk of relying only on end samples, but does not prove that the entire coil meets the requirement.

2. Check Dimensions and Surface Quality

Verify thickness and width against the purchase order. Inspect the surface for scratches, rust, stains, dents and uneven coating. Selected coils should be opened so inspectors can check the actual condition rather than relying only on the outer wrapping.

3. Test Mechanical Properties

Where required by the order, check tensile strength, yield strength and hardness against the agreed specifications. These properties should also suit the buyer's intended application.

4. Check Packaging and Labels

Inspect the wrapping, edge protection and strapping to ensure the coils are properly protected for transport.

Pay particular attention to the product description on the labels. In some markets, including Malaysia, Saudi Arabia and Indonesia, importers may need to register or declare product descriptions before shipment. Inconsistent descriptions can cause customs clearance problems.

Confirm label details with the buyer by email before production, then check them again during pre-shipment inspection.

5. Review Inspection Documents

Check the mill test certificate (MTC), inspection report and packing list against the purchase order. Product descriptions, specifications and coil details should be consistent across the documents.

How SIMCO Inspects GI Coils

SIMCO arranges routine inspections for every shipment. Inspection is based on sampling, not a full inspection of every coil. Typically, one or two coils are randomly selected for each specification, or according to the buyer's requirements.

Selected coils are opened for inspection. Checks include dimensions, zinc coating weight, surface condition, mechanical properties where required, packaging and labels. SGS or another third-party inspection agency can also be arranged upon request.

Routine inspection does not include weighing every coil. If shipment weight verification is required, loaded trucks can be weighed at the port.

Final Checks Before Shipment

Before shipment, buyers should confirm three things: the zinc coating weight meets the agreed requirement, the product condition matches the specification, and the labels and documents are correct.

A reliable inspection starts with clear requirements and representative sampling.

← Back to Insights
— Read more

Latest insights