Published 2026-10-21
Zinc coating mass is an important specification when buying galvanized steel coils. It affects the amount of zinc available to protect the steel, but the coating designation must be understood in the context of the applicable standard.
Zinc coating mass is expressed in grams per square metre (g/m²).
Under EN 10346 and ASTM A653, the coating designation generally refers to the minimum total coating mass on both surfaces, not the mass on each side.
For example, under EN 10346, Z275 specifies a minimum total coating mass of 275 g/m² under the triple-spot test. The corresponding single-spot minimum is 235 g/m².
Not every commercial coating requirement follows these standard designations. If a buyer specifies a light coating such as 30 g/m², the purchase specification should clearly state that this is the required total mass on both sides and define how it will be verified.
Generally, a higher zinc coating mass provides more zinc for corrosion protection and can extend the service life of galvanized steel.
The actual result depends on the exposure environment, including humidity, pollution, salt exposure and the time the surface remains wet. Forming, scratches and exposed cut edges also affect performance.
Coating mass alone cannot determine the service life of a finished product.
Before placing an order, specify:
Coating mass can be verified using agreed test methods under the applicable standard.
Standards such as EN 10346 and ASTM A653 distinguish between triple-spot and single-spot test requirements. Their acceptance limits are not necessarily the same.
Buyers should agree on the applicable test method and acceptance criteria before production. A coating designation should not be interpreted as a requirement for every individual measurement to equal the nominal figure.
A clear RFQ avoids misunderstandings between buyers, suppliers and mills.
For example:
For non-standard light coatings, state the required coating mass, both-side or one-side basis, and agreed acceptance method explicitly.
Do not compare coating prices or specifications until the measurement basis and applicable standard are clear.
SIMCO supplies galvanized steel coils in different coating specifications for construction, roofing, appliances and industrial applications. Coating requirements are confirmed against the customer's specification and intended use.